Lightnin’ Grip Loader INSTRUCTIONS
1. Slide open the Bullet Reservoir Cover and drop in up to fifty (50) 22LR cartridges.
2. Close cover. Gently shake the Cliploader, keeping it level and the reservoir cover on top.
3. Raise the reservoir end to slide the cartridges in tothe Loading Channel.
4. Repeat #2 and #3 until the Loading Channel fills sufficiently.
5. Raise the reservoir end and smoothly squeeze thetrigger to load a round into the magazine.
The triggerneeds to return to the nearly out position to seat the round and stage another bullet for loading.
It is usually a good idea to count the bullets going in to know when to stop. It is possible to force in an extra round.
NOTE: Quickly snapping the trigger in can cause the bullets to bounce in some magazines and “hook” the rims in the wrong direction making them hard to get out.
Sometimes a hard rap on the bottom of the magazine with your palm or on a book will bounce the bullets to unhook them.
TIPS:
• Bullets are not feeding---------
Some 22LR cartridges are real sticky with wax lube. After
filling the reservoir, give them a shot of Remington (Rem Oil)
Teflon Spray Lube. Only a small amount is needed.
Caution! The unit is molded from Lexan, and some lubes will
attack it.
• Not all magazines fit the same; you may need to apply a
little seating pressure against the magazine as you are loading it.